Hello. I'm new to the site but I've been reading it for a few weeks now. I'm currently at a 14g. Had them for about a month. Last night, some junk was hanging behind my left ear lobe. I'm guessing it was dead skin cells. Well I went to the bath room and cleaned my plugs.
Well just now, I felt my left earlobe again and noticed I couldnt feel the o-ring. It was inside the earlobe. My right plug is fine. No problem with that ear.
What can i do to prevent this? should I take my plug off for a while? Any help would be appreciated. Thank you!
O-ring going inside earlobe?
Re: O-ring going inside earlobe?
Sum peoples ears dont react well to the oring being so close to the lobe. I would just not wear o rings.
Left Lobe = 1 3/8in.
Right Lobe = 1, 3/8 in.
16g Bridge/Earl
14g/ 16g spider bites both sides
14g Tongue
6g Septum
Upcoming:
16g Angel bites
Retired:
Industrial
Right Lobe = 1, 3/8 in.
16g Bridge/Earl
14g/ 16g spider bites both sides
14g Tongue
6g Septum
Upcoming:
16g Angel bites
Retired:
Industrial
Re: O-ring going inside earlobe?
I have some larger o-rings that came with some plugs i bought. maybe I can use those so they cant go inside?
-
- Posts: 16
- Joined: Wed Sep 01, 2010 7:45 pm
- Gauge Size:: 1 inch
- Location: Royal Oak, Michigan
- Contact:
Re: O-ring going inside earlobe?
I hate o-rings personally. But if you're deadset on keeping the o-ring plugs go get yourself a thicker o-ring. not larger, thicker. Perhaps that will help?
1" lobes
14g prince albert
one tat more to come yee haw!
14g prince albert
one tat more to come yee haw!
Re: O-ring going inside earlobe?
Well, they came withe plugs I bought. Is it possible to wear the plugs without the o-rings? I'd think they'd fall out.JAMESD00DCHILL! wrote:I hate o-rings personally. But if you're deadset on keeping the o-ring plugs go get yourself a thicker o-ring. not larger, thicker. Perhaps that will help?
-
- Posts: 16
- Joined: Wed Sep 01, 2010 7:45 pm
- Gauge Size:: 1 inch
- Location: Royal Oak, Michigan
- Contact:
Re: O-ring going inside earlobe?
Yes, it is possible but yes again; they will fall out.
My local peircing/plug stand in the mall has all sizes of o-rings. If you have a place like that, go get thicker o-rings so they fit snugly and are bigger than your size!
My local peircing/plug stand in the mall has all sizes of o-rings. If you have a place like that, go get thicker o-rings so they fit snugly and are bigger than your size!
1" lobes
14g prince albert
one tat more to come yee haw!
14g prince albert
one tat more to come yee haw!
-
- Posts: 251
- Joined: Mon Jun 21, 2010 11:58 am
- Gauge Size:: 5/8"
- Location: Bouncing between St Paul, MN and Utica, New York
Re: O-ring going inside earlobe?
Give some breathing room between the plug and your ear, your piercing does need to breathe a bit. Having the o-rings too tight against the piercing can cause it to embed like that.
I usually tell people to wear o-rings one size Smaller than the gauge they are wearing. That way the o-rings will fit tight on the Plug without having to be so tight against the skin.
I usually tell people to wear o-rings one size Smaller than the gauge they are wearing. That way the o-rings will fit tight on the Plug without having to be so tight against the skin.
It's not a revolution, it's a lifestyle.
Re: O-ring going inside earlobe?
Your ear can get really irritated and inflamed if you can't get it out soon enough
. There's tons of alternatives. A lot of good options have been mentioned in the thread already or you could find some jewelry that doesn't require plugs to stay snug. Good luck!

-
- Posts: 3
- Joined: Thu Jun 16, 2011 5:27 am
- Gauge Size:: 10g
Re: O-ring going inside earlobe?
How do you get them out? Like what ways are there to get them out? I have the same problem and I'm at a size 10 and I found 2 size 16s in my left earlobe and there might be one more in there
-
- Posts: 3
- Joined: Mon Jul 11, 2011 9:14 am
- Gauge Size:: 3.2mm
- Location: Plymouth, england
Re: O-ring going inside earlobe?
I'm a compete noob at stretching, so don't know how good this advice is, but I had a similar problem. Wen going from 1.5mm to 2.4mm I stretched using my taper then slapped in my single flared tunnels (with large o rings). But whilst asleep my ear swelled, pulling the flare through the ear. So my new code of practice is to stretch and leave the taper in (with the o rings set loose) just 4a couple days, 2 let the ear settle b4 putting in the tunnels. Hope that helps although dunno if its accurate/the right thing 2 do?
Embrace the pain, pain is ur friend! Pain is good, it means ur alive! (my philosophy 4 tattoos and life in general, not stretching!)
Stretching both ears out to 14mm (3.2mm at present)
Full sleeves, ribs , back, calf, knee-cap, chest and groin tattoo's
Stretching both ears out to 14mm (3.2mm at present)
Full sleeves, ribs , back, calf, knee-cap, chest and groin tattoo's