Bit confused about sizing,if someone can offer suggestions
Bit confused about sizing,if someone can offer suggestions
OK,so I was at 00 for about a month now,& decided to increase my size.Just got done putting in my 7/16" tunnels,which had to have been the easiest stretch EVER,much to my pleasant surprise!
I actually had to wipe off some of the oil I used because it was too slippery.I'm thinking I may eventually go up again in a another month or two,but I'm a bit confused as to what's next.Some sites I see list 12mm & 1/2 as two separate sizes,but not always.So if I do go up in a month or two,should I specifically get ones that say 12mm,or 1/2,or are they considered the same since there's only about a 0.5-0.7 difference? 
AkPhilly,
Philadelphia,PA

3/4" (19mm) earlobes
14g industrial
12g tongue
7 tattoos
retired septum (though considering resurrecting it
,monroe,navel
WANT: both conchs,& microdermal,& more tattoos!
Philadelphia,PA

3/4" (19mm) earlobes
14g industrial
12g tongue
7 tattoos
retired septum (though considering resurrecting it
WANT: both conchs,& microdermal,& more tattoos!
-
bradykay90
- Posts: 258
- Joined: Sun Jun 17, 2012 5:23 am
- Gauge Size:: 1/2" lobes
- Location: Texas
Re: Bit confused about sizing,if someone can offer suggestions
as hand tools they are different. But as for jewelry the are considerd the same size. I have no clue why but yea. They are
My left lobe is 1/2" my right is 00g.


